This can be achieved by following the procedure below:Ģ) In the Object Properties dialog box, go to the Connectors tabģ) Select “ Inside object” in the dropdown listĤ) Increase the value for “ If next connector > ” to 3mm or more by using the sliding bar in the value box. If the lettering part in the emb file is the lettering object, then you need to adjust Connectors parameter for the lettering object. You have found that there are too many trims between letters when stitching on your machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |